Your shopping cart is empty!
93 грн
  0 reviews
Promotions and discounts
Sending parcels at 16.00

100 grit Silicon Carbide (SiC) bar, designed for rough machining of workpieces requiring a large amount of metal removal.

It is used mainly in the initial stages of sharpening for configuring leads, as a rule, without reaching the burr. It can also be useful when regrinding blades (changing the angle of sharpening) and eliminating serious damage to the cutting edge (chips, notches). In the cases described, it is recommended to use this stone before abrasives of 220-240 grit to reduce the load on them and prevent abnormal wear on the working surface of the bars.

The stone is delivered without a glued blank, all 4 sides along the length of the bar can be used. Before use (sharpening or leveling processes), the stone must be soaked in water.

Country of manufactureUkraine
TypeBar
Profile typeRectangular
Scope at the initial stages of sharpening
MaterialSilicon carbide (SiC)
Bond typeCeramic
Stone grit 100 grit
Length150.0 (mm)
Width25.0 (mm)
Height10.0 (mm)

Basic

Equipment
without the form
Reviews: 0

There are no reviews for this product.

Questions: 0

No questions about this product.

Similar Products