Your shopping cart is empty!
Model:
12450
Brand:
Tandy
413 грн
  0 reviews
Promotions and discounts
Sending parcels at 16.00

Riveting hand tool for mounting copper and brass rivets (Rivtun, Copper Rivet & Burr) produced by Craftool, is used for fitting a washer onto the rivtun leg, fixing it and riveting it. The riveting hand tool with reference 8110-01 is used for setting rivets with a stem diameter of 3.4mm (face cap diameter of 9mm). The riveting tool is made of hardened steel, resistant to shock loads. It has two holes for the rivet leg (end and side, they are used to stuff the washer on the rivet leg), as well as a round end inside for expanding the open end of the rivet and washer. To install holnitens, a punch (cutter) of holes is also required, into which the leg of the rivet enters. The diameter of the cutter should correspond to the diameter of the leg or be slightly larger so that the base of the cap easily enters this hole and the cap is pressed tightly against the parts of the material to be joined.

The diameter of the end hole of the riveting hand tool with reference 8110-01 is 3.7 mm, the depth is 20 mm, it is intended for mounting rivets, the stem diameter is 3.4 mm (the diameter of the front cap is 9 mm). The diameter of the side hole of the riveting hand tool with reference 8110-01 is 3.7mm, the depth is 5.5mm, it is also intended for mounting rivets, the stem diameter is 3.4mm (the diameter of the front cap is 9mm). The diameter of the end round-shaped sub-inside for flaring is 8 mm, its depth is 1 mm. The length of the rivet tool 8110-01 is 118mm, the diameter of the holder is 13mm. There is a tactile notch on the handle, eliminating slippage of the tool during operation. The weight of the riveting tool 8110-01 is 110 grams.

Reviews: 0

There are no reviews for this product.

Questions: 0

No questions about this product.

Similar Products
Riveting tool (8110-00)
413 грн
Tapered awl 120mm
47 грн
Cord Guardian Minicord Black 1m.
7 грн